exabyte Posted January 14, 2014 Report Share Posted January 14, 2014 Взех на старо един 2950, но има някаква останала конфигурация, като има сложена явно и boot парола.Ето какво изписва/става когато се свържа през конзолния порт: This computer system should only be accessed by authorised users who have undertaken appropriate training. Access by unauthorised users may constitute an offence under the Computer Misuse Act 1990, for which they may be prosecuted. The Data Protection Act 1998 applies. User Access Verification След което ме пита за Username, но без да натискам нищо ми въвежда само Username-a "Q1": Username: Q1 Pass % Aution failed. Username: 1 Password: % Aution failed. Username: Q1 Pass % Aution failed. EDU-Haverstock-2950-1 con0 is now available Press RETURN to get started. И при натискане на Enter, всичко се повтаря. Успях да вляза в рековърито, но дори и там спама с Q1 продължаваше.Въпреки всичко, тъй като има малко забавяне докато го въведе, успях да изпълня:flash_init после:load_helper При което изписа следното и всичко започна да се повтаря на ново. Link to comment Share on other sites More sharing options...
Administrator Велин Posted January 15, 2014 Administrator Report Share Posted January 15, 2014 аз до сега винаги съм ги ресетвал вързан с ком кабелче и натискаш бутона докато тисе появи менюто за ресет Не отговарям на постове написани с шльокавица! Link to comment Share on other sites More sharing options...
jazzpar Posted June 6, 2014 Report Share Posted June 6, 2014 Cisco 2950 Switch Password Recovery 1. Unplug the power cable. 2. Hold down the mode button while replugging the power cable. 3. Type flash_init over the console. 4. Type load_helper 5. Type Dir flash : //make sure to type the semi-colons 6. Type rename flash:config.txt flash:config.old //the password is contained in the config.txt file 7. Type boot //this reboots the system 8. Type n to skip the initial setup configuration. 9. Type enable //this takes you to the enable mode 10. Type rename flash:config.old flash:config.txt 11. Save config.txt to system: #copy flash:config.txt system:running-config 12. Enter config mode and change the password: # config t # no enable secret //this applies only if the enable secret password was created 13. Finally, write the changes to memory: # write memory http://www-tss.cisco.com/eservice/compass/common/activities/password_cat_2950.htm Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now